Roving Networks WIFLY GSX Instrukcja Użytkownika Pobierz pdf (Strona 5)

www.rovingnetworks.com Version 1.32r 10/9/2012 5

RN-WIFLY-EVAL-UM

Table 3. RN-171-EK Evaluation Board LED Indicators

Condition

Blue LED

Red LED

Yellow LED

Green LED

On solid!

Not used!

Connected over TCP

Fast blink!

Not used!

Not associated!

Rx/Tx data transfer!

No IP address

Slow blink!

Not used!

Associated, no Internet!

IP address OK

Off!

Not used!

Associated, Internet OK!

HARDWARE SETUP

To set up the evaluation hardware, perform the following steps:

1. Provide power to the board:

• RN-131-EK—The USB cable supplies power to the board.

• RN-171-EK—Insert 2 AAA batteries into the battery pack. Alternatively, the USB cable can supply power to

the board.

2. Connect the USB cable to a USB port on your computer and to the USB connector on the evaluation board.

Windows should automatically install the drivers for the cable. If it does not, download and install the FTDI drivers

from the Support page on the Roving Networks website at http://www.rovingnetworks.com/support.php. Note the

COM port to which you have attached the cable.

Figure 3 shows the completed hardware setup for the evaluation boards.

Figure 3. Hardware Setup

RN-131-EK Evaluation Board Hardware Setup

RN-171-EK Evaluation Board Hardware Setup

1 2 3 4 5 6 7 8 9 10 ... 21 22

Brak uwag

Roving Networks WIFLY GSX Instrukcja Użytkownika Strona 5